Featured
How To Flush The Water Heater
How To Flush The Water Heater. Close the water supply valve to the heater. Tankless water heaters are more efficient than traditional tank water heaters, but they can still get dirty.

Turn back on the cold water into the heater. In conjunction with this, turn the water heater thermostat down. Shut off the water supply
Leave It On For An Hour Or So And You Have A Clean Water Heater.
This will help prevent a vacuum from forming in the lines while you’re draining the hot water tank. Let the vinegar sit for about 6 hours. Only eligible for single hvac unit households.
After The 6 Hours Connect A Garden Hose To The Drain Valve And Open It To Drain Out The Vinegar.
Turn on hot water in tub. Turn this to the off position. If you have a water softener between your mainline and the water, be sure to shut off the valve there as well.
Set Your Thermostat To “Pilot” Mode.
Older homes may require you to shut off the water where the main water supply line enters the house. Once it starts running clear, you can turn the water off. Turn off the cold water supply to hot water heater the cold water valve is usually near the top of your hot water heater.
This Will Ensure The Tank Can Be Completely Drained.
Flush the heater for five or ten minutes. Allow the heater to run for a few minutes to flush out any remaining sediment. Or you can completely turn it off.
Connect Your Garden Hose To The Drain Valve At The Bottom Of The Water Heater.
Flushing & cleaning water heater at this point, you have drained the tank of water. Let the water cool turn off the water heater. Allow water to run through the heater and out of the drain valve.
Comments
Post a Comment